What are the reasons for the damage of hydraulic cylinder seals?
The oil leakage of hydraulic cylinder should be considered whether it is due to the problem of the hydraulic cylinder seal. Therefore, the low qualification rate of the hydraulic cylinder seal device directly affects the normal operation of the cylinder.
The reasons for the damage of the hydraulic cylinder seal are:
1. I am not familiar with the structure;
2, dust and impurity pollution;
3, outdoor open air;
4, bumped by external force;
5, the product failure rate is low;
6, the device direction is wrong;
7. The device is illegal.
For the above reasons, pay attention to the following points:
1. The installation personnel are required to have a fundamental understanding of the structure of the hydraulic cylinder.
2. Before and after disassembly, try to create conditions to prevent the hydraulic cylinder from being contaminated by dust and impurities. All parts should be covered with plastic sheet after disassembly.
3. Ensure that the hydraulic oil in the hydraulic oil tank is clean, clear and free of impurities.
4. The piston rod is concentric, and the surface is lubricated, without large rust spots and pits.
5. Ensure that the hydraulic cylinder seals are qualified and all certificates are complete.
6. When installing Y-shaped and V-shaped sealing rings, pay attention to the installation direction to prevent oil leakage due to installation. For the Y-type sealing ring, its lip should deal with the pressure oil cavity. In addition, the Y-type and V-type sealing ring should pay attention to the difference is that the shaft is used for the hole, so do not install it wrong.
7. When installing O-rings, do not pull them to the extent of permanent deformation, and do not roll them over; special tools should be used for the snap-key or snap-ring in the device.