What to do when the cylinder is maintained?
By using clean hydraulic oil, the impurities in the hydraulic oil will block the passage, wear parts and shorten the service life of the cylinder. Confirm the amount of hydraulic oil before use to ensure the right amount of oil. It is best not to use hydraulic parts if there are not enough If the oil leaks into the air, it will cause noise from the hydraulic equipment. If the oil leaks, if the seals of the hydraulic components are worn or damaged, and are verified in time, the output of the hydraulic components will be insufficient.
Due to long-term use, foreign matter will inevitably enter the oil cylinder, resulting in increased friction during use. In addition, the hydraulic oil also has a certain life span. If the oil is not replaced for a long time, it will damage or corrode the inside of the oil cylinder. This is better Avoid pressure, so the speed should be no more than 2 m/s in the cylinder, which can prolong the life of the cylinder and protect the mechanism and safety. The installation action appropriately controls the internal buffer device to protect the cylinder.
Regarding the oil tank leakage, it not only causes environmental pollution and waste of resources, but also affects normal production mines and causes serious losses. Therefore, it is necessary to take specific maintenance measures in time.
Hydraulic components play an important role in all mechanical equipment. They are relatively easy to be damaged. They need to be repaired and replaced after damage. This requires a lot of time and work. Through rational use and maintenance of hydraulic components, the service life of hydraulic components can also be improved and saved Cost, improve work efficiency, to prevent the piston from colliding with the cylinder head from the two ends of the cylinder, resulting in noise, affecting the accuracy of the workpiece or even damaging the machine, usually a buffer device provides a hydraulic pump station in the system, its function is to use oil The acceleration principle is used to realize the braking of moving parts.